Memory

Default Memory Access Permissions

The Cortex-M3 memory map has a default configuration for memory access permissions Default memory access permission is used when either:

No MPU is present
MPU is present but disabled Otherwise MPU will determine When a memory access is blocked the fault exception takes place immediately.


import pymupdf

from PIL import Image

doc = pymupdf.open("./pdf/L4.pdf")

pix = doc[12].get_pixmap()
img = Image.frombytes("RGB", [pix.width, pix.height], pix.samples)
plt.axis('off')
plt.subplots_adjust(left=0, right=1, top=1, bottom=0)
plt.imshow(img)

plt.show()

MPU(Memory Protection Unit)

MPU

Regions can be overlapped only in ARMv7

Bit-Band Operations

it allows a single load/store opertation to access a single data bit.

Bit-band regions:

The first 1MB of the SRAM region
The first 1MB of theperipheral region

They can be accessed via a separate memory region called the bit-band alias.

Bit-Banding done transparently by bus matrix.

Write to Bit-Band Alias

Without Bit-Band:

LDR   R0, =0x20000000 ; Setup address
LDR   R1, [R0]        ; Read
ORR.W R1, #0x4        ; Modify bit
STR   R1, [R0]        ; Write back result

With Bit-Band:

LDR   R0, =0x22000008 ; Setup address
MOV   R1, #1          ; Setup data
STR   R1, [R0]        ; Write

Read from the Bit-Band Alias

To get bit 2 in word data in address 0x20000000:

Without

LDR    R0, =0x20000000 ; Setup address
LDR    R1, [R0]        ; Read
UBFX.W R1, R1, #2, #1  ; Extract Bit[2]

With

LDR R0, = 0x22000008 ; Setup address
LDR R1, [R0]         ; Read

Advantages of using bit-band ops

Faster bit operations with fewer instructions
Prevent a race condition problem in bit modification

Usecase in C

There is no native support of bit-band ops in most C compilers
- The simplest solution is to separately declare the address and the bit-band alias of a memory location

#define DEVICE_REGO      *((volatile unsigned long *) 0x40000000)
#define DEVICE REGO_BIT0 *((volatile unsigned long *) 0x42000000)
#define DEVICE REGO_BIT1 *((volatile unsigned long *) 0x42000004)

Unaligned Transfers

Coretex-M3 optionally supports unaligned transfers on single accesses. Data memory accesses can be defined as aligned or unaligned.

Unaligned transfers are converted into multiple aligned transfers by the processor's bus interface unit:

transparent to application programmers
it takes more clock cycles for a single data access

Limitations:

Not supported in load/store multiple instructions
Stack operations (PUSH/POP) must be aligned
Exclusive access must be aligned
Unaligned transfers are not supported in bit-band ops

2.7 KiB Raw Permalink Blame History